Cleaning Mode - Roborock S4 Manual Del Usuario

Instructions for use
Scheduled cleanup
Use the Mi Home app to set start times and suction levels for
scheduled cleanups. The robot will return to the charging dock
after each cleanup.
Pin n go
Use the Mi Home app to set a destination for the robot. It will then go
to that point.
Zone cleanup
Use the Mi Home app to draw a specific zone for the robot to clean.
Note: While cleaning the designated zone, the robot may move outside zone borders.
Make sure that there are no cables or obstacles placed close to the cleanup zone.

Cleaning mode

Use the Mi Home app to chose from Quiet, Balanced, Strong, or
MAX modes. The Balanced mode is the default.
In DND mode, no cleanups will start, no voice alerts will play, and the
power indicator will dim. DND mode is set from 22:00 to 08:00 by
default and can be disabled or modified in the Mi Home app.
Virtual no-go zone and barrier
The Mi Home app can be used to draw virtual no-go zones and barriers
to keep the robot from entering the areas you define.
Note:
"Map Saving Mode" must be turned on in the Mi Home app to use virtual no-go zones.
Virtual no-go zones and barriers should only be used to customize the cleaning area. It
should not be used to isolate hazards.
Moving the robot manually or making significant changes to the home environment may
cause the loss of virtual no-go zones and barriers
Virtual barrier
Virtual no-go zone
016