Power And Speaker Connections - MTX Audio RFL4001D Manual De Instrucciones

180°
Thank You !
Thank you for purchasing an MTX Audio High-End amplifier. Proper installation matched with MTX speakers and subwoofers provide
superior sound and performance for endless hours of waking the neighbors, slammin' your friends or flat out stomping wanna-be
players. Congrats and enjoy the ultimate audio experience with MTX !
Specifications :
• Mono block class-D amplifier
• CEA2006 certified Power Output :
- 4000 Watts RMS x 1-channel at 1 ohm and THD+N ≤1%
- 2400 Watts RMS x 1-channel at 2 ohm and THD+N ≤1%
- 1500 Watts RMS x 1-channel at 4 ohm and THD+N ≤1%
• Crossover :
- Low pass 24dB/oct variable from 40Hz to 150Hz
- Subsonic filter 24dB/oct at 20Hz
• Signal-to-Noise Ratio (1 Watt) : > 95dB
• THD+Noise (Distortion) (1 Watt) : ≤ 0,08%
• Frequency Response (±0,5dB) : 10Hz-150Hz
• Maximum Input Signal : 6V
• Maximum Sensitivity : 200mV
• Phase switch 0° or 180°
• EBC remote control
• Bridged mode with gain management
• Dimensions : 626mm x 204mm x 59mm

Power and Speaker connections :

GND REM +12V GND REM +12V
Power Power
GND REM +12V
Power
Ground Terminal – A proper ground is required for your amplifier to operate at peak performance. A short ground cable the same
diameter as the power cable should be used to attach the ground terminal directly to the chassis of the vehicle. Always remove paint,
dirt or debris to expose bare metal where the ground cable will be attached.
Remote Terminal – The amplifier can be turned on by applying 12 volts to this terminal. Typically this voltage is supplied by a wire from
the source unit marked "remote" or "power antenna".
(+12) Power Terminal - This is the main power input for the amplifier and must be connected directly to the positive terminal of the
vehicles battery for proper operation. Use caution when installing (+12) power cable in the vehicle. Avoid running this cable parallel
with RCA cables, antennas, or other sensitive equipment due to massive currents that can induce noise into the audio system. It is also
very important to have a tight, secure connection for maximum performance. MTX recommends using 50mm 2 power wire with the
MTX RFL4001D amplifier.
Speaker Terminals - Connect subwoofer(s) to these terminals. If using two subwoofers or a dual voice coil subwoofer, respect the phase.
Attention : The two (+) connectors are wired parallel internally. Same for the two (-) connectors.
GND REM +12V GND REM +12V
Power Power
Input
Ch.1 Ch.2
Gain Subsonic Low Pass Phase
6V - 0,2V On Off 40Hz - 150Hz 0° 180°
GND REM GND +12V
Bridge Mode EBC
Remote
Slave
Master
Power Power
Input
Ch.1 Ch.2
Gain Subsonic Low Pass Phase
6V - 0,2V On Off 40Hz - 150Hz 0° 180°
Bridge Mode EBC Data Link
Remote
Slave
Master
REM +12V
Speakers
(+)
Data Link
Speakers
(-)
(+)
Bridge Mode EBC Data Link
Remote
Slave
Master
Speakers
(-)
(+)
GND REM +12V
(-)
Power