Packing List - EarthWise CS33014 Manual Del Operario

UNPACKING
This product requires some assembly.

PACKING LIST

- Chain Saw
- Guide Bar
- Chain
- Bar Cover
- Combination Hex Key/Screwdriver
- Instruction Manual
INSTALLING/ REPLACING THE GUIDE BAR AND CHAIN
DANGER: Never start the motor before installing the guide
bar, and chain. Without these parts in place, the clutch can
fly off or explode, exposing the user to possible serious injury.
WARNING: To avoid serious personal injury, read and
understand all the safety instructions provided.
DANGER: Before performing any maintenance, make sure
the tool is unplugged from the power supply. Failure to heed
this warning could result in serious personal injury.
CAUTION: Always wear gloves when handling the bar and
chain; these components are sharp and may contain burrs.
WARNING: Never touch or adjust the chain while the motor
is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the chain
to avoid possible serious lacerations.
NOTE: When replacing the guide bar and chain, use only
identical replacement parts.
•
Disconnect chain saw from power supply. Lay the chain
saw on flat surface.
•
Unscrew the locknut counterclockwise from the chain
cover with the hex key provided.
•
Remove the chain cover.
ASSEMBLY
Chain Cover Locknut
Carefully remove the product and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping. Do not discard the
packaging material until you have carefully inspected and
satisfactorily operated the product.
WARNING: If any parts are damaged or missing do not
operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury. Call
1-800-313-5111 for assistance.
INSTALLING/ REPLACING THE BAR AND CHAIN
(The first 3 steps below are for replacing the bar and
chain).
•
Remove the bar and chain assembly from the mounting
surface.
•
Turn the chain tensioning screw counterclockwise with the
screwdriver provided to loosen the chain tension if
necessary.
•
Remove the old chain from the bar.
6
Chain Tensioning
Screw