Receiver Side; Remote Control Function - Winner M532-34 Manual De Empleo

Receiver Side

Problems
There is no audio/video on TV
Cannot select the sources on
the transmitter
Cannot change the sources on
the transmitter
Cannot control the sources on
the transmitter
Bad reception
Interference on TV

Remote Control Function

Problems
Cannot operate using remote
control
selected properly
Possible Causes
Power adapter for receiver is
not plugged in
Receiver is not turned on
Sources on transmitter side
are not turned on
Signal cables for the sources
on transmitter side are not
plugged in
Signal cable for the TV is not
plugged in
TV cable is plugged in the
wrong port
TV display mode
selected properly
VCR on the receiver side is
playing
Discrepancy in
between the transmitter and
receiver
UHF remote control is out of
range
Discrepancy in
between the receiver
transmitter
IR extender is not connected
to the transmitter
IR extender is not facing the IR
sensor of the selected source
2.4GHz channel interference
Power adapter for transmitter
is not plugged in properly
Transmitter is not turned on
TV display mode
selected properly
Discrepancy in
channel selection
receiver and transmitter
Possible Causes
No battery inside the remote
control
Battery is running low
Battery is not
properly
Solutions
Plug in the power adapter
Turn on the receiver
Turn on the sources
Plug in the signal cables for
the sources
Plug in the signal cable to the
TV
Plug the TV cable to the
correct port
is not Adjust the TV display mode
Turn off the VCR
Family ID Make
setting for receiver is the same
as transmitter
Shorten the usage range
Family ID Make
and setting for receiver is the same
as transmitter
Connect the IR extender to the
back panel of the transmitter
Face the IR extender and
sensor of the selected source
to each other
Change the channels on both
the receiver and transmitter
Make sure the power adapter
for the transmitter is well
plugged in
Turn on the transmitter
is not Adjust the TV display mode
2.4GHz Set the same channel between
between the receiver and transmitter
Solutions
Put in AAA batteries
Change new batteries
positioned Adjust the battery to the
correct polarity
sure the Family ID
sure the Family ID