Assigning An Effect Module; Unassigning An Effect Module - Kemper PROFILER REMOTE Inicio Rápido

REMOTE QUICK START 11

ASSIGNING AN EFFECT MODULE

Assigning switching functions to the Effect Buttons is simple: just press and hold an Effect Button on the Remote for
example Effect Button IIII and press the desired module button, e.g. Module D, on the front panel of the PROFILER at
the same time. Done!
It also works the other way around: press and hold the module button on the PROFILER first, then step on the
desired Effect Button afterwards. The upper left LED of the Effect Button should now reflect the category color of
the effect you assigned e. g. orange for a wah effect. Now, you can activate or bypass the selected effect module by
stepping on the button on your PROFILER Remote. The lower left white LED indicates the on/off status of this effect
module.

UNASSIGNING AN EFFECT MODULE

To undo a current assignment, simply perform the same assignment procedure again. Gone! The upper LEDs remain
unlit if no effect is assigned.