Phase Linear UMP301 Manual Del Usario página 9

UMP301
OPERATING INSTRUCTIONS
Seek Mode Selector
4
1. Press and hold the SEL button (4) for more
than 2 seconds to access the menu.
2. Continue pressing the SEL button to select
"SEEK" mode.
3. Press the volume +/– buttons (3) to select
"SEEK 1" or "SEEK 2".
• SEEK 1: Station search will stop when
the next station is received.
• SEEK 2: Station search will stop when
the tune/track ( , ) button (6a or 6b)
is released and the next station is
received.
Turn On Volume Setting
4
1. Press and hold the SEL button (4) for more
than 2 seconds to access the menu.
2. Continue pressing the SEL button to select
"VOL ADJ" mode.
3. Press the volume +/– buttons (3) to select
one of the following modes: "VOL LAST" or
"VOL ADJ".
• VOL LAST: When the unit is turned on,
the volume will resume at the level
selected when last turned off.
• VOL ADJ: After selecting "VOL ADJ", use
the volume +/– buttons (3) to set the
desired turn-on volume level.
5 AM/FM Band Selector (BAND)
During radio play, each time the BAND button
(5) is pressed, the radio band changes. The
indications "AM1", "AM2", FM1", "FM2", or
"FM3" will appear on the display panel
according to your selection.
Tuning Control
6
Press the tune/track ( ) button (6a) to
manually tune the radio higher, or the tune/track
( ) button (6b) to manually tune lower.
Press and hold either the up or down tune/track
button (6a and 6b) to seek the next strong
station.
FM Mono Select (ST/MO)
7
During FM radio operation, the ST/MO button
(7) is used to select monaural or stereo
reception of the broadcast signal. Under normal
reception conditions, the unit should be left in
the stereo mode (indicated by "STEREO" when
tuned to an FM stereo signal). If the signal is
too noisy for comfortable listening, press the
ST/MO button; the "STEREO" indication will
disappear from the display panel and "MONO"
will appear. To return to stereo reception mode,
press the button again.
9
Auto-Store/Pre-Set Scan
8
(AS/PS)
Press the AS/PS button (8) momentarily to
scan the 6 stations in the pre-set memory for all
FM bands. The unit will stop at each pre-set
station for 10 seconds. Press AS/PS again to
stop scanning and select the current frequency.
Press and hold the AS/PS button for more than
2 seconds to activate the Auto-Store Tuning
feature. The radio will automatically scan the
band in use and enter the six strongest stations
into the pre-set memory positions for that band.
Auto-Store will erase any stored stations.
Local Button (LO/DX)
9
During radio operation, received signals are
usually in stereo mode as indicated by the "ST"
icon; however, when the signals are weak or
intermittent, you can activate the Local mode by
pressing the LO/DX button (9) ("LOCAL"
appears on the display). This mode favors
access to local stations whose signals are
much stronger; thereby improving radio
reception. Press the LO/DX button again to
terminate Local receive mode ("- DX -" appears
on the display).