Sony HT-NT3 Instrucciones De Operación página 28

[Network Settings]
 [Internet Settings]
Connect the system to the network
beforehand. For details, see "Network
Function" (page 16).
[Wired Setup]: Select this when you
connect to a broadband router using a
LAN cable. When you select this setting,
the built-in wireless LAN is disabled
automatically.
[Wireless Setup(built-in)]: Select this
when you use the built-in wireless LAN
of the system for wireless network
connection.
Tip
For further details, visit the following
website and check the FAQ:
http://www.sony.com/soundbarsupport
 [Network Connection Status]
Displays the current network
connection status.
 [Network Connection Diagnostics]
You can run the network diagnostic to
check if the network connection has
been made properly.
 [Screen mirroring RF Setting]
If you use multiple wireless systems,
such as a wireless LAN (Local Area
Network), the wireless signals may be
unstable. In this case, playback stability
may be improved by setting the priority
radio frequency channel for Screen
mirroring.
[Auto]: Normally select this. The system
automatically selects the better channel
for Screen mirroring.
[CH 1]/[CH 6]/[CH 11]: The selected
channel is prioritized for Screen
mirroring connection.
28
US
 [Connection Server Settings]
Sets whether or not to display the
connected Home Network server.
 [Auto Renderer Access Permission]
[On]: Allows automatic access from a
newly detected Home Network
controller.
[Off]: Off.
 [Renderer Access Control]
Displays a list of Home Network
controller-compatible products and sets
whether or not to accept commands
from the controllers in the list.
 [External Control]
[On]: Allows the home automation
controller to operate this system.
[Off]: Off.
 [Remote Start]
[On]: Allows turn on the system by a
device linked via network when the
system is in standby mode.
[Off]: The system cannot be turned on
by a device linked via network.
[Input Skip Setting]
The skip setting is a convenient feature
that allows you to skip unused inputs
when selecting a input by pressing
INPUT +/–.
[Do not skip]: The system does not skip
the selected input.
[Skip]: The system skips the selected
input.
Note
If you press INPUT +/– when the home
screen is displayed, input icon appears
dimmed if it has been set to [Skip].