Remote Control; Connecting The Receiver; Replacing The Batteries In The Receiver; Inserting Or Replacing The Batteries In The Remote Control - Dru Verwarming FIRE COUNTRY RC Manual De Instalación Y Guía Del Usuario

INSTRUCTIONS FOR INSTALLATION
• Sprinkle the bag of embers (the bag with black contents),
on top of the vermiculite to create a glowing effect on the
burner bed.
• Now lay the other logs as illustrated.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
the oxypilot as this could influence the flue-gas safety
device.
Do not use any materials other than those supplied.
Nothing should be thrown on the burner bed, no rubbish
either, except the intended materials with the log set. The
supplied materials are incombustible and have been manu-
factured specifically for this appliance.
For safety reasons a guard should be placed in
front of the fire at all times.

Remote control

Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.

Connecting the Receiver

The remote control system comprises a receiver and a
remote control, packed together in one box. The receiver
must be connected to the appliance fitting the batteries.
This is done as follows:
• Take the receiver out of the box.
• Slide the plug of the cable onto the receiver circuit board
(fig. 9).
• Connect the wires to the connectors on the gas control
valve.The different sized plugs correspond with the con-
nectors on the gas control valve.
• Open the lid.
• Insert 4 penlight batteries (type AA). Make sure they are
the right way round.
• Replace the lid.
fig. 8
• Place the reciever in the ashpan. Make sure that the red
LED points to the front.
• NB: Fit the receiver
as far away from the
burner tray as pos-
sible to prevent the
receiver from
getting too hot.

Replacing the batteries in the receiver

• Open the flap at the front.
• Take the reciever and open the cover.The batteries are
under that cover.
• Remove the old batteries and insert the new ones, making
sure that the + and – signs on the batteries correspond
with those in the holder.
Inserting or replacing the batteries
in the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
• The temperature is shown on the display in Fahrenheit,
press both buttons for a few seconds and it will change to
Celsius.
NB: Do not throw old batteries in the dustbin.They
should be treated as Chemical Waste.
10
fig. 9