Operating Instructions; Lighting; Remote Control; Pilot Light Setting - Dru Verwarming FIRE COUNTRY RC Manual De Instalación Y Guía Del Usuario

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Lighting

Press button A and turn to the left to the small flame
The flame will ignite at
If that is the case, hold button A firmly pressed for anoth-
er 5 seconds.Then release button A and check that the
pilot light is still burning. Now turn button A to the large
flame , which will open the main valve of the control
block. Depending on the setting of the control button B,
high or low flames will be visible. If the ignition does not
work properly, relight.

Remote Control

The height of the flames can be regulated by remote con-
trol, which will turn button B on the gas control block.
Press the bottom button ( ) on the remote control for
a smaller flame.When you push the button above ( )
and the little button at the remote control at the same
time, the flames become higher. Manually adjusting button
B will have the same effect. A certain force is required
when rotating button B, a clicking sound is quite normal.

Pilot light setting

If the heater is not in use but you would like the pilot
light to remain alight, set button A to the small flame.
The gas supply to the main burner will then be discon-
nected.

Switching off

Turn button A to the "0" setting.The gas supply to the
burners will then be disconnected.

Important

A built-in safety lock is activated when the appliance is
switched to "OFF" (closed down setting).Therefore, wait
5 minutes before relighting the heater.Within this period,
do not try to push the lighting button, as this has been
blocked by the safety lock. Do not force the button, as
this may result in damage to the mechanism.
fig. 10
. Check that the pilot is alight.
.
11
Fire