Fanimation Enigma FP2120 Serie Manual Del Proprietário página 5

How to Assemble Your Ceiling Fan (cont'd)
6. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 3a) Remove the Pin from the
Downrod, then remove the Hanger Ball. Retain the Pin
and Hanger Ball for reinstallation in Step 9.
7. Separate and untwist the three wires and the safety
cable. Route the leads through the Downrod.
8. Loosen the two setscrews in the Downrod Support.
Align the Clevis Pin holes in the Downrod with the holes
in the Downrod Support. Install the Clevis Pin and secure
with the Hairpin Clip. (Figure 3b)
9. Pass the Downrod/Hanger Ball Assembly through the
top of the ceiling canopy and push the bell-shaped motor
coupling cover on to the downrod as shown. (Figure 4)
NOTE: You will be using either the 6" downrod supplied
with your fan or an optional downrod purchased
seperately.
▲WARN I N G
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
10. Loosen the two setscrews in the downrod support.
Align the clevis pin holes in the downrod with the holes
in the downrod support. Install the clevis pin and secure
with the hairpin clip (Figure 3). The clevis pin must go
through the holes in the downrod support and the holes
in the downrod. Be sure to push the straight leg of the
hairpin clip through the hole near the end of the clevis pin
until the curved portion of the hairpin clip snaps around
the clevis pin. The hairpin clip must be properly installed
to prevent the clevis pin from working loose. Pull on
the hanger ball to make sure the clevis pin is properly
installed.
11. While pulling up on the hanger ball, securely tighten
the two setscrews in the downrod support (Figure 3).
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
12. Slide the motor coupling cover down until it touches
the top of the motor.
13. The fan comes with a support cable, blue, black,
orange and white leads. Before installing fan, measure
up approximately 6-9 inches above top of Downrod/
Hanger Ball Assembly. Cut off excess cable and wire.
Strip back insulation ½" from end of each wire.
Setscrew
Hanger
Ball
Assembly
Figure 3a
14. You have now completed the assembly of your new
ceiling fan. You can now proceed with the hanging and
the electrical wiring of your fan.
5
Hairpin
Pin
Clip
Setscrew (2)
Figure 3b
Ceiling
Canopy
Motor
Coupling
Cover
Figure 4
Downrod
Support
Clevis
Pin