Entering Advanced Configuration; Mode; Entering Frequencies Values - Motorola RVA50UL Manual Del Usuario

Entering Advanced Configuration Mode
Note: Before configuring the features, make sure
your radio is set to the channel you wish to
program. You can do so before entering
Advanced Configuration Mode or at any
time during the Advanced Configuration
Mode by rotating the Channel Selector Knob
until you reach the desired channel.
To read or modify Frequencies, Codes, Auto-
Scan, Active Channels and Weather Channel
set the radio to 'Advanced Configuration Mode'
by long pressing both the PTT and the SB1
button simultaneously for 3 to 5 seconds while
turning ON the radio until you hear an audible
voice saying "Programming Mode" and
"Channel Number". The LED Indicator starts
blinking a green heartbeat.
Note: 'Idle' Programming Mode is the stage in the
Programming Mode where the radio waits
for the user to start the radio programming
cycle.
32
English
Once you are in the 'Idle' Programming Mode,
you will be able to hear the Frequencies,
Codes, Auto-Scan, Active Channels and
Weather Channel settings by short pressing
the PTT button to navigate along the different
programmable features.

Entering Frequencies Values

RVA Series radios have 48 frequencies for
UHF and 60 frequencies for VHF.
In 'Idle' Programming mode, the Channel
number becomes the first changeable value.
Select the desired channel by turning the
Channel Selector Knob. An audible voice
indicated the selected channel to configure.
Short pressing the PTT button allows you to
cycle through the other features available for
configuration. Use the SB1 and SB2 button to
change the values. An audible voice indicates
the value selected.