GE Evolve ERS1 Guia De Instalacion página 4

Luminaria led para vía pública
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6
FINAL ASSEMBLY POWER
MODULE DOOR
• To replace door, hold it at an angle of approximately
35 degrees from vertical and toward pole side of
hinge.
• Carefully insert hinge pin into hinge and allow door to
hang free.
• Note that door is mechanically interlocked with top
housing in all positions except in the vicinity of
removal location.
• All units: The doors are designed to be assembled to
top housing while in upright position with gravity
holding hinge pin properly in the cradle.
• If door is to be assembled to top housing while lying
on its back, extreme care should be taken to ensure
that hinge pin is properly engaged in the cradle by
lifting up rear of door. Otherwise, breakage may occur.
7
MAINTENANCE / CLEANING
WARNING
Risk of electric shock. Make certain power is off before
attempting any maintenance.
• The optical compartment has no serviceable parts.
• To maintain high efficiency of the lens, occasional
cleaning of the outer lens surface may be needed,
with frequency dependent on local conditions.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in
connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not
covered sufficiently for the purchaser's purposes, the matter should be referred to GE Lighting.
g
GE Lighting • 1-888-MY-GE-LED
GE Lighting is a subsidiary of the General Electric Company. Evolve and the GE brand and logo are trademarks of the General Electric Company.
© 2013 GE Lighting. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
• Use a mild soap or detergent, which is essentially
neutral pH (pH approximately 6 to 8), nonabrasive,
and which contains no chlorinated or aromatic
hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
8
STORAGE
• Prior to installation, units should NOT be stored
outside in corrugated boxes (cardboard boxes) alone.
• Until installation, all units should be placed in a
covered dry storage area. The storage area should
not exceed -40°C (-40°F) to 50°C (122°F).
-
This can be preferably in a roofed area or with a
tarp that is secured in such a way to keep water
off of the corrugated boxes (cardboard boxes).
• www.gelighting.com
(1 - 888 - 69 - 43 - 533)
35-201578-201 (Rev 01/09/18)
English

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Evolve ers2

Tabla de contenido