Coleman HWOD 2302-A Serie Instrucciones De Uso página 5

To Set Up (continued)
To power socket on heater
THIS SIDE UP
WATER PUMP CONNECTION
• Pump end (Fig. 3):
1. Place the water carrier at a level below the water heater
for proper drainage.
2. Screw the water pump to the opening of the water
container & hand tighten.
3. Lay the water container on its side so the pump is
towards the bottom of the container (step 2).
4. Make sure to rotate the pump where "THIS SIDE UP" is
facing upward so pump will prime and water will flow.
TIP: You can also submerge The Water Pump into an open
water container such as a cooler (cooler not included). Or if available, you can connect a garden hose directly to the unit. Ensure water flow is not too high,
this will affect the ability of the unit to heat water and could possibly force the outlet connection to disconnect. Conversely ensure water flow is not too low,
this can cause a low flow error. Ensure water is flowing before lighting the unit and adjust flow as required.
• Heater end (Fig. 4):
1. Plug the pump power jack into the pump power socket on the heater.
2. Plug the sleeved connector of the pump into the water inlet on the heater. (Follow same steps A, B, C, D given in section "SHOWER CONNECTION")
SHOWER ARM INSTALLATION
1. Dismantle The Shower Arm by screwing off
the adjustment knob (Fig. 5).
2. Install The Shower Arm to the rail on
heater, and tighten by screwing on the
adjustment knob. (Fig. 6)
3. Loosen the Adjustment Knob and adjust
the angle & height of The Shower Arm,
once the desired position is reached,
tighten the adjustment knob (Fig. 7).
4. After the Shower Arm is installed, you may put The Shower onto The Shower Arm.
GAS CYLINDER INSTALLATION (FIG. 8)
This appliance shall only be used with 1 lb. Coleman Propane LPG disposable gas cylinders
certified to DOT-39 NRC 232/290 M1110. IT MAY BE HAZARDOUS TO ATTEMPT TO
FIT OTHER TYPES OF GAS CONTAINERS. Check that all seals between the appliance
and the gas cylinder are in place and in good condition before connecting the gas cylinder.
Remove all transit protection material. DO NOT move the appliance during operation. After use,
turn off the control knob.
Do not use MAPP gas cylinders or any other fuel except propane.
1. Turn the control knob to OFF position.
2. Remove cap from the propane gas cylinder but do not discard.
3. While holding the propane cylinder upright, thread it into The Regulator.
To water inlet
on heater
To water
carrier / tank
Fig. 3
Fig. 5
REGULATOR
Fig. 4
A B
D
C
Fig. 6 Fig. 7
Fig. 8
OFF
5