Rear Panel - Denon DJ X1800 Prime Guia Del Usuario

42. FX Time: Turn this knob to select the rate that the BPM effect module will use. Press the knob
to switch between adjusting the rate as a time division and the rate in milliseconds. (A
corresponding light along the FX touch strip will illuminate to indicate the current time division.)
43. FX Touch Strip: When the Instant button is off (disabled), tap an area of this touch-
capacitive strip to select the time division that the BPM effect module will use. A
corresponding light along the strip will illuminate to indicate the current time division. If the
current time division is not a quantization value shown on the strip (e.g., the BeatBreak
effect), then none of the lights will illuminate.
When the Instant button is on (enabled), tap and hold your finger on the strip to activate
the effects, and then drag your finger up or down to adjust the time division of the effect.
44. Tap: Tap this button at least 3 times the desired tempo to set the rate of all time-based
effects. Press and hold this button for 1 second to set the tempo to that of FX Channel
Assign knob's channel (e.g., if Channel 2 is using an effect with a rate of 135 BPM and the
FX Channel Assign knob is set to Channel 2, pressing and holding this button will set the
rate of time-based effects on all channels to 135 BPM).
45. FX Frequency: Turn this knob to select a frequency band of the audio signal to which the
BPM effects will be applied. Select the center (12:00) position to apply effects to the entire
spectrum of frequencies.
46. Utility: Press this button to enter or exit the Utility menu, which will appear in the display.
Exiting the Utility menu also saves any changes you made.
47. MIDI Send: Press this button to send a MIDI Start message out of the USB port or MIDI
output (you can use the Utility menu to select one). The tempo will be that of the selection
of the FX Channel Assign knob. If you change the selection of the FX Channel Assign
knob, press and hold this button to send the new tempo.
48. Engine Connect: When the Link ports are connected to SC5000 Prime units, press this
button to enable X1800 Prime to receive timing and BPM information (to synchronize
effect tempos) and to send track and user profile data between SC5000 Prime units.
49. USB Ports: Use standard USB cables to connect computers to these USB ports.

Rear Panel

1. Power Input: Use the included power cable to connect this input to a power outlet.
2. Power Button: Press this button to power X1800 Prime on or off. Power on X1800Prime
only after you have connected all of your input devices and before you power on your
amplifiers and loudspeakers. Power off your amplifiers and loudspeakers before powering
off X1800 Prime.
8
1
2
8
4
5 6
11
10 10 10 10
9
15
14
7
3
16
13
12
3 3 3 3