E-Viii. Installation - Der Koch Eltz Manual De Instalación Y Funcionamiento

Plantillas de Vitrocerámica

E-VIII. Installation

The installation must be carried out by a suitably
qualified person, in accordance with the current version
of the following. Before connecting the appliance, make
sure that the supply voltage marked on the Rating Plate
corresponds with your mains supply voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
• This appliance should be wired into a 13 A double pole switched fused
spur outlet, having 3 mm contact separation and placed in an easily
accessible position adjacent to the appliance. The spur outlet must
still be accessible to enable the appliance to be disconnected from
the mains supply.
• Care must be taken to avoid the cable being in contact with hot
parts of the appliance.
• The appliance must not be connected to the mains supply by means
of a 13A plug and socket.
•
Positioning the appliance
• The kitchen area should be dry and aired and equipped with efficient
ventilation. When installing the ceramic, easy access to all control
elements should be ensured.
• This is a Y-type design built-in ceramic, which means that its back wall
and one side wall can be placed next to a high piece of furniture or a
wall .Coating or veneer used on fitted furniture must be applied with a
heat-resistant adhesive (100℃).This prevents surface deformation or
detachment the coating.
• Hoods should be installed according to the manufacturer's instructions.
www.derkochline.com
Ceramic Hob
39