Rinse Agent; Rinse Agent Dispenser - Thermador DWHD650G Serie Manual De Uso Y Cuidado

Rinse agent

To achieve proper drying, always use a liquid rinse agent, even if your detergent
contains a rinse agent or drying additive.

Rinse agent dispenser

Open the rinse agent dispenser by lifting the tab with your thumb.
NOTE: Your dishwasher indicates low rinse agent either by showing the symbol
in the display, or illuminating the rinse agent LED (model dependent). If the symbol
is displayed or the LED is on, you need to reill the rinse agent dispenser.
Add liquid rinse agent to the dispenser as shown until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir
is full.
Setting amount of rinse agent
The amount of rinse agent dispensed can be set from "r:00" to "r:06".
To change setting:
• Open the door.
• Turn unit on by pressing the [ON/OFF] button.
Hold down [NORMAL] button and press and hold [START] until the display
•
indicates "H:00".
• Release both buttons.
• Press [NORMAL] until the display indicates "r:00".
Press [QUICK CLEAN] to select the desired setting.
•
• "r:00" = dispenser is of
• "r:01" = lowest setting
• "r:02" = low setting
• "r:03" = medium setting
• "r:04" = medium high setting
• "r:05" = high setting
• "r:06" = highest setting
• Save the selected setting by pressing [START].
• Close the door.
Turning of rinse agent reill indicator
• Set the rinse agent option to "r:00" by following the above steps.
NOTE: Do not change the amount of rinse agent unless there are streaks (select
lower setting) or water stains (select higher setting).
8