Kenmore 796.8077 Serie Guia De Uso Y Cuidado E Instrucciones De Instalacion página 19

PROCEDURE OF CONTROL PANEL CHANGE (cont.)
Assemble
Put the hooks of the panel into the left side holes of
frame correctly.
Next the surface of the A is located in the higher
place than the surface of the B.
Then, Push the panel until it is aligned three holes
on the top of the frame.
1. Attach the panel by sliding to the left in clicks into
place.
2. Turn the screw to the right.
3. Close the cap.
WARNING
Be sure the screw is properly tightened.
If it isn't, the control panel could come off.
Control Panel
Attach the safety cover.
WARNING
Be sure to install the safety cover to avoid
electric shock.
Safety Cover
INSTALLATION INSTRUCTIONS
B
A
Frame
Cap
19
1. Attach the lower cover in the upper position
where the control panel was removed.
2. Tighten the screw.
3. Push the cap.
WARNING
Be sure the screw is properly tightened.
If it isn't the lower cover could come off.
Install the hooks of the plate in the holes of the
frame.
Slide the plate to the left until it clicks into place.
Cap