Intended Use; Product Features; Technical Data; Noise/Vibration Information - Bosch PSM 80 A Manual Original

OBJ_DOKU-2339-002.fm Page 14 Thursday, December 13, 2007 2:40 PM
14 | English

Intended Use

The machine is intended for dry sanding and pol-
ishing of wood, filler and coated surfaces. It is es-
pecially suitable for profiles, corners or hard to
reach locations.

Product Features

The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 On/Off switch
2 Dust box, complete (micro filtersystem)
3 Sanding plate
4 Sanding sheet*
5 Extraction outlet
6 Filter element (micro filtersystem)
7 Vacuum hose*
*The accessories illustrated or described are not in-
cluded as standard delivery.

Technical Data

Multi Sander
Article number
Rated power input
No-load speed
No-load orbital stroke rate
Sanding sheet surface
Orbit diameter
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the prod-
uct are: Sound pressure level 83 dB(A); Sound
power level 94 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
1 609 929 N20 | (13.12.07)
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value a
ty K <1.5 m/s
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
PSM 80 A
Identify additional safety measures to protect the
3 603 C54 0..
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
W 80
hands warm, organisation of work patterns.
rpm 11250
opm 22500

Declaration of Conformity

2
cm 104
We declare under our sole responsibility that the
mm 1.4
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
kg 0.9
to the provisions of the directives 2004/108/EC,
/ II
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
07.11.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
2
=6.5 m/s , Uncertain-
h
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools