ICAN 30-300 Instrucciones De Uso página 42

5 (GB)
PUTTING ON THE ICAN HALF
MASK:
1. With one hand, hold the mask in front of
the face and place it so that the mouth,
nose and chin are covered. Then pull the
head straps over the head, and place the
two-piece headband behind the head.
2. Then take the bottom straps in both hands,
place them behind the neck and fasten
them together.
3. Pull the head straps and the bottom straps
tight. The impermeability of the mask
can now be checked before entering the
working area.
CHECK BEFORE USE :
ICAN HALF MASK must always be checked before use in order to ensure that the
half mask is not damaged and is clean. It is extremely important that a mask
leakage test (see below) is always carried out before use.
MASK LEAKAGE TEST:
Place the palms of your hand over the open filter
housings (plastic film or pieces of cardboard can also be
used to cover the openings if your palms are not
sufficiently large). Gently breath in and hold your
breath for about 10 seconds. If the mask is sucked in
towards the face, then it is correctly adjusted. If any
leakage can be felt, the straps should be adjusted in
order to stop the leak. If a correct fit cannot be
achieved, then a detailed examination of the mask's
individual components is necessary. Note that the size
of the mask can be highly significant with regard to
achieving the correct fit.
PUTTING ON - TEST
 copyright 2002