General Description; Introduction; Main Features; Build Characteristics - ZIGOR SOLAR XTR3 Manual De Operación

Operating Manual
2 GENERAL

2.1 Introduction

The ZIGOR SOLAR XTR3 is a single phrase solar inverter. It is responsible for converting the direct
current generated by photovoltaic panels into alternating current for injection into the electrical power
distribution grid.
The ZIGOR SOLAR XTR3 can be used both to back up consumption and as a system to produce
electricity. In the first case, if the electrical power consumption of the location in which the inverter is
installed is lower than the power consumed by this unit, excess production is delivered to the grid. If this
consumption exceeds production, the energy required to complete the balance is taken from the
electricity grid. In the second case, all the power generated by the equipment is injected into the
electricity grid. In both cases, the appropriate power measurement systems must be installed for each
use.
The installation of the ZIGOR SOLAR XTR3 and its connection to the electricity grid shall be done in
accordance with local regulations and may require the installation of adequate electricity consumption
measuring devices.
The PV inverter only operates when it is connected to the electrical power distribution line and cannot
operate as a stand-alone unit.

2.2 Main features

 System is designed transformerless: remember that the photovoltaic modules must be A class
according to the standard IEC 61730
 Euro efficiency upper to 96%.
 High input range of voltage: from 300Vdc to 800Vdc.
 MPPT efficiency upper to 99%.
 Firmware can be update easily.
 3 MPPT independent inputs.
 Detection modes of Islanding failure: active and passive.
 Internal GFCI (Ground fault circuit interrupter).

2.2.1 Build characteristics

The cabinet of the ZIGOR SOLAR XTR3 is built for operating indoors or outdoors. The protection level of
this system is IP54. The most important build characteristics of the equipment are as follows:

IP54 enclosure.

Alternating current output: 400Vac 50/60Hz.

Industrial and domestic range components.

Optimised, intelligent refrigeration system.

The unit shall be installed on a wall.

All the connections enter at the bottom of the cabinet.
4
DESCRIPTION
Fig. 2-1 Simplified diagram of the inverter connection
ZIGOR SOLAR XTR3
© ZIGOR