General Maintenance - Craftsman 320.39587 Manual De Instrucciones

A
WARNING: Before cleaning or performing any maintenance, make sure that
the sheet sander has been disconnected from the power source.
,_ WARNING: Always wear safety goggles or safety glasses with side shields
when using compressed air to clean the tool. If the operation is dusty, also wear a
dust mask.
CLEANING THE DUST
BAG (Fig. 7)
For more efficient operation,
empty the dust bag when it is
no more than half full. This will
permit the air to flow through the
dust bag better. Always empty
and thoroughly clean the dust bag
when you've finished sanding and
before you store the sander.
Fig. 7
Frame
Dust bag
Slot Steel ring
To empty the dust bag
1. Disconnect the sheet sander from the power source.
2. Remove the dust bag from the sander and shake out the dust.
3. For a more thorough cleaning of the dust bag, remove the dust bag from the
frame and shake out the dust bag (Fig. 7).
4. Use a soft brush to clean the frame.
5. Replace the dust bag over the frame, then reinstall it on the sander.
NOTICE: When replacing the dust bag over the frame, make sure that the steel
ring in the dust bag snaps into the slot of the frame.
WARNING: Collected sanding dust from sanding surface coatings such
as polyurethanes, linseed oil, etc., can self-ignite in the sander dust bag or
elsewhere and cause fire. To reduce the risk of fire, always empty the dust bag
frequently while sanding and never store or leave a sander without
totally emptying its dust bag. Also follow the recommendations of the coating
manufacturer.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to damage from various types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. Keep all
ventilation openings clean.
i6