Delta 36-6022 Manual De Instrucciones página 20

ASSEMBLY
TOOTH
DIRECTION
K
FRONT OF
SAW
ARBOR
SHAFT
FIGURE 19
a
FIGURE 20
Place blade (K) on the arbor shaft with the teeth on the blade pointing toward the front of the saw. Place flanged washer
on the shaft with the large side of the washer against the blade, then secure blade assembly with nut. (Figure. 19)
Tighten nut with blade wrenches (a). Open end wrench will fit on the arbor shaft between the inner flange washer and the
motor assembly (if neccessary, turn arbor shaft to align flats on the arbor shaft to the wrench). Closed end wrench will fit
on the nut. See Figure 20.
Return wrenches (a) to onboard storage location. Position the riving knife in the "Thru-cut" position prior to installation of
thoat plate.
Details for positioning the riving knife are on page 32 RIVING KNIFE POSITION AND ALIGNMENT Section.
See Figure 21.
20