Pair The Remote Transmitter And Receiver Collar - Petsafe ST-100 Manual De Funcionamiento

STEP 4
Pair the Remote Transmitter
and Receiver Collar
If your Receiver Collar does not beep when
the Tone Button of the Remote Transmitter is
pressed, or if you feel the Receiver Collar
is not responding to the Remote Transmitter,
follow these steps to pair:
1. Start with the Receiver Collar off your pet
and powered off.
2. Press and hold the On/Off Button until
the Green LED light shuts off. When the
Green LED shuts off, release the On/Off
Button and the Receiver Collar LED will
fl ash green.
3. Place the Remote Transmitter into pairing mode by pressing the
Stimulation Down (-) Button until the Digital Display shows P.
4. Press the Tone and Stimulation Buttons simultaneously (the Orange
LED should be lit) until the Receiver Collar fl ashes the Green LED 5
times, indicating it has learned the Remote Transmitter ID.
5. Change the level to 1 Low by pressing the Stimulation Up (+)
Button on the Remote Transmitter and then press the Tone Button.
The Receiver Collar should emit a tone, verifying that it is paired
with the Remote Transmitter.
6. If the Receiver Collar does not respond, please contact the
Customer Care Centre.
18 www.petsafe.net