Operation; Choke Control - Craftsman 247.88955 Manual Del Usuario

Drive Control
Chute assembly
Clean Out
Tool
augers
Now that you have set up your snow thrower, it's important to become
acquainted with its controls and features. Refer to Figure 10.
sHift LeVer
The shift lever is located on the dash panel. Place the shift lever into
any of eight positions to control the direction of travel and ground
speed.
forward
Your snow thrower has six forward (F) speeds. Position one (1) is the
slowest and position six (6) is the fastest.
reverse
Your snow thrower has two reverse (R) speeds. One (1) is the slower
and two (2) is the faster.
Craftsman Snow Throwers conform to the safety standard of the American National Standards Institute (ANSI).
Gas Cap
Oil fill
Skid Shoe
meets ansi safety standards

OPERATION

Shift lever
Primer
ignition
Key
Throttle
Control
Choke
Control
Oil Drain
Figure 10
ignition key
The ignition key is a safety device. It must be
fully inserted in order for the engine to start.
Remove the ignition key when the snow thrower
is not in use.
NOTE: Do not turn the ignition key in an attempt
to start the engine. Doing so may cause it to
break.

CHoke ControL

The choke control is found on the rear of the
engine and is activated by turning the rotary
choke knob to the ON position. Activating the
choke control closes the choke plate on the
carburetor and aids in starting the engine.
12
auger Control
Chute Directional Control
Recoil Starter
Handle
Electric Start
Button
Electric Starter Outlet