ML.book Page 6 Tuesday, November 29, 2016 10:45 AM
SiriusXM Tuner Input Connector
To SiriusXM Tuner.
Radio Antenna Receptacle
Speed Sensor Lead (Green/White)
Improper connection of the speed pulse line may cause
important safety features of the vehicle to fail (such as the
brakes or air bags). Such failures may result in an accident and
loss of life. We strongly recommend that the installation be
performed by a trained, authorized Alpine dealer.
Direct CAMERA Input Connector
Use when the optional direct camera is connected.
• When using the optional Multi Camera Interface module, you can
connect up to 3 cameras: Front camera, Rear camera, and Side
camera.
iDataLink Interface Connector
To iDataLink module.
AUX Input Connector
Input lead for AUX video/audio signal or iDataLink audio signal.
• A separately sold AV/RCA interface cable (4-pole mini AV plug to
3-RCA) is required. For details on using an AV/RCA interface
cable (4-pole mini AV plug to 3-RCA), see "Usable AV/RCA
Interface Cable (4-pole mini AV plug to 3-RCA)" (page 7).
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or
signal processor.
Reverse Lead (Orange/White)
Connect to the plus side of the car's reverse lights. These lights
illuminate when the transmission is shifted into reverse (R).
With this lead properly wired, the video picture automatically
switches to the rear camera whenever the car is put into reverse
(R).
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if
applicable.
• This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of parking brake
switch to transmit the parking brake status signals to the unit.
6
-EN
01GB04X208U-US_EN.fm
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse box
or another unused power source that provides (+) 12V only
when the ignition is turned on or in the accessory position.
Fuse Holder (15A)
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is securely
fastened using the sheet metal screw provided.
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Gray/Black)
Right Front (+) Speaker Output Lead (Gray)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Remote Control Output Lead (Brown) (For DVD Player
DVE-5300)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Remote Control Output Lead (Brown) (For Rear Monitor)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Remote Control Input Lead (Brown/White)
Connect the external Alpine product to the remote control
output lead.
ALPINE X208U/INE-W977HD 68-34732Z04-A (EN)