NHT UL 5. 2 OPERATION HELPFUL HINTS at the start of each day. 7 - For good product conservation the dispenser must run 1 - Granita viscosity adjustment: proper Granita viscosity is overnight, at least in Soft Drink mode. factory preset. To change the viscosity, if needed, use a standard screwdriver to turn the adjustment screw located If this is not possible and product is left in the bowls overnight, the mixer/refrigeration switches must be set to...
NHT UL approved lubricant. front notch engages with the exposed end of the auger shaft (see figure 14). figure 11 figure 14 3 - Assemble the faucet by reversing the disassembly steps 7 - Push the bowl towards the rear wall of the unit until it fits (see figure 10) snugly around the gasket and its front fastening hooks are 4 - Fit bowl gasket around its seat.
Página 11
NHT UL automatically freezes down again to Granita setting viscosity. figure 18 To operate the defrost timer proceed as follows (see figure 18). 1 - Set the time of the day by rotating the dial clockwise (arrow A). Never rotate the timer counterclockwise as this would damage the internal mechanism.
NHT UL 1 - Colocar el interruptor general en la posición I. refrigeración en la posición I; ésto evita la formación de 2 - Ajustar los interruptores mezcladores y refrigeración: bloques o crostas de hielo que podrían dañar los - en la posición I si se quiere refrigerar el producto sin dispositivos mezcladores.
Página 20
SPARE PARTS LIST 2427_49 V 1.5 08A08 NHT UL...
Página 21
Transparent cover Tapa trasparente Drip tray Cajón recoge-gotas Flexible contact Gomita con contacto 00263 00595 Bowl Contenedor Relay Relé Fixing ring Anillo de fijacón 00638 00177 Faucet piston Pistón del grifo Overload protector Guardamotor Thermostat Termostato 00420 00132 Faucet piston OR Junta OR del pistón grifo Starting-run capacitor Condensador de arranque...
Página 22
GEAR MOTOR SPARE PARTS LIST Bracket with bush Soporte con buje Ball bearing ý 28 mm Cojinete de bolas ý 28 Gear box cover Tapa de la caja reductor 00097 00247 00721 Stator Estator 1.5 mm spacer Distancial 1,5 mm. Rotor Rotor 00156...