End Of Season Storage; Troubleshooting - Global Air NPA1 Serie Manual De Uso Y Cuidados

End of Season Storage

1. Screw off the drain cover, pull out the stopper to drain wat er completely.
2. Keep unit running in fan mode with half day to dry inside completely to prevent it from going mouldy.
3. Turn off the unit, pull out plug then wrap the power c ord around the wire-winding pillar, insert the plug int o the
universal fixing hole at the back panel of the unit, install the water plug and drain cap.
4. Remove the heat exhaust hose assembly, clean and keep it properly.
5. Pack the air-conditioner properly with soft plastic bag and put it in dry place with appropriate dust -proof measures,
and keep the unit away from children.
6. Take out the batteries from the remote control and keep it properly.
Note:

The tilt angle of unit must be less than 30 degrees.

Hold the exhaust hose assembly with both hands when removal.

Push the fasteners aside on ex haust air outlet using your thumbs, then pull out exhaust hose assembly.

Assure the unit is stored in a dry place. All accessories of the unit shall be prop erly protected together.

Troubleshooting

Please check unit and suggestions below before asking for professional service, but never dismantle or repair the unit
by yourself, it may cause harm to you and your property.
Trouble
The unit fails to start up
Bad cooling effects
High noise level
The compressor does
not work
The remote cont rol does
Caus e
Power supply failure
Water-full and its indicator lighting
Ambient temperature too low or too
high?
The room temperature is lower than
the set temperature in cooling mode.
There is direct sunlight
The doors and windows are open, the
room is crowded or there are other
heat sources
Dirty filter
Air inlet or air outlet clogged
The unit is being placed at uneven
surface.
Initiation of overheat protection.
Too long distance
Connect the unit to a live socket and turn it
on.
Drain the water stored in the unit.
It is recommended to use this unit between
10-35℃（50-95℉.）
Change the set temperature
Close the curtain
Close the door and window, remove other
heat sources, and add new air-conditioners
Clean or replace the filter mesh
Remove the obstruction
Put the unit at a flat and firm place (may
reduce noise)
Wait until the temperature decreas e, the unit
will re-start automatically
Bring the remot e control close to the
16
Remedy