13. Fill the Pet Fountain Bowl with water. Make sure the water level is at least to the
minimum MIN (minimum) fill line so the Pump does not run dry. This will prime the
Pump for use. Do not fill the Pet Fountain past the MAX (maximum) fill line.
14. Place Pet Fountain in desired location. Do not pick up a full Pet Fountain by the Cone
piece. To properly pick up the Pet Fountain, use both hands and grip the sidewalls
of the Bowl and lift. Important: To protect your floor always use a protective mat,
such as a towel or water-resistant placemat. This will help protect your floor from
splashing or spills caused by your pet.
15. Make sure the electrical Power Cord, the Adaptor and your hands are completely
dry before you plug the Pet Fountain into an electrical outlet. Connect the Inline Plug
and make sure no silver is showing, then plug the Adaptor into an electrical outlet.
16. Add water to Pet Fountain as needed. Never let the water level fall lower than the
MIN (minimum) fill line (approximately 2.5 cm above the bottom of the Bowl) or you
may risk burning out the Pump. Replacement Pumps are sold separately by calling a
Customer Care Centre. Visit www.petsafe.net for a telephone listing of the Customer
Care Centre near you.
filters and pet fountain Cleaning
filter System
The Pet Fountain is equipped with two types of filters that should be replaced on a regular
basis. The Charcoal Filter removes bad tastes and odours, keeping water fresh. The Foam
Filter collects hair, debris and pet food and prevents them from reaching the Pump,
providing optimal filtration. The filters together will keep the Pump cleaner and provide
fresher water to your pet.
Charcoal filter: Filters should be changed every two to four weeks.
Replace filters more frequently when using the Pet Fountain for multiple pets
or pets that produce a lot of saliva. Important: Always rinse the Charcoal
Filter prior to use. A small amount of charcoal dust may be released for the
life of the filter, this is normal and is not harmful to your pet.
foam filter: Replace the Foam Filter every four to six weeks, depending
on the location of the Pet Fountain and the number of pets using it. If you do
not intend to replace the filter at the time of cleaning, rinse the Foam Filter
thoroughly with fresh water.
Filters are an added feature of the Pet Fountain. Using the filters is not
required for normal operation. However, when used properly and changed regularly,
the filters help keep the water cleaner and fresher, while extending the life of your Pet
Fountain. Filters may be rinsed out when the Pet Fountain is cleaned. Important: Never
wash the filters with soapy water, as the soap residue will seep into the filters and cannot
be removed. Only rinse the filters with water.
www.petsafe.net
9
.