Parts Supplied; Charcoal Filter Replacement; Installation Instructions - Thermador RECHMCB Manual Del Usuario

Parts Supplied

1 - Hardware bag
• 4 - 4x8 mm installation screws
1 - Charcoal Filter
1 - Air deflector

Installation Instructions

If it is not possible to vent cooking fumes and vapors to
the outside, the hood can be used in the non-vented
(recirculating) version, using the recirculating kit .
Fumes and vapors are recycled through grid.
1. Assemble the air deflector with the duct cover bracket
using (4) 4.2 x 8 mm screws.
C
2. Measure from the bottom of the air deflector to the
bottom of the hood outlet.
B
X
D
E
3. Cut the duct to the measured size "X."
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over the
exhaust outlet from the hood.
7. Reassemble the air deflector to the duct cover bracket
with the four assembly screws.
8. Use duct tape or vent clamps to seal the deflector and
the exhaust outlet from the hood.
Page 4
A. Mounting screws
B. Air deflector
C. Duct cover bracket
A
B
A
C
A. Air deflector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet

Charcoal Filter Replacement

In the recirculating mode, the air will be recirculated
through disposable charcoal filters that help remove smoke
and odors.
• Remove the grease filter of the hood.
• Position the charcoal filter inside the structure of the
motor as shown in picture.
• Reinstall the grease filter onto the bottom of the hood.
NOTE: The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).