Publicidad
Idiomas disponibles
Idiomas disponibles
Fastener Caution
Caution: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that
application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specified. These
coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and
specifications when installing fasteners in order to avoid damage to parts and systems. When using fasteners that are threaded
directly into plastic, use extreme care not to strip the mating plastic part(s). Use hand tools only, and do not use any kind of
impact or power tools. Fastener should be hand tightened, fully seated, and not stripped.
Torque-to-Yield Fastener Warning
Warning: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use
fastener when installing this component. Failure to replace the torque-to-yield or single use fasteners could cause damage to the
vehicle, component, or bodily injury.
Removal Procedure
1. Remove the front tire and wheel assembly.
2. Front Brake Rotor Cooling Duct Deflector Bolt (1) » Remove [3x]
3. Front Wheelhouse Splash Shield Fasteners (1) » Remove [4x]
4. Front Wheelhouse Splash Shield Fasteners (2) » Remove
5. Front Wheelhouse Splash Shield Retainer (3) » Remove
6. Front Wheelhouse Splash Guard (4) » Remove
Camaro Suspension Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
84242387
IR 23SE16
PART NO.
DATE
23SE16
Initial Release - Andrew Rogers
4
SHEET
REVISION
54
OF
AUTH
2546929
Publicidad
