Dyna-Glo DGSS962CBO-D Manual Del Usuario página 13

ASSEMBLY INSTRUCTIONS
15. Insert the end of the grease cup support (M) into
the hole located on the bottom of the smoker
body (C). Thread the support through the hole
until the support is hanging as shown.
Note: This grill does not include a container for
catching grease or liquids from inside the smoker
body. Use a discarded aluminum can with
minimum diameter of 2 1/4" (58mm) and slide
the top lip of the can onto the grease cup support
(M) as shown. See Page 3 for disposing the can
after use.
16. Attach the right shelf bracket (N) to the grill
body (C), using two M6 x 12 bolts (AA) and two
M6 nuts (BB), and insert the shelf support wire
into the bracket, as shown. Insert the shelf
supports into the left shelf bracket (O), before
securing the bracket with two M6 x 12 bolts (AA)
and two M6 nuts (BB).
Hardware Used
M6 x 12mm
AA
Bolt
M6 Nut
BB
15
16
x 4
x 4
13
C
M
C
BB
O
N
AA