Read Menu - AERMEC ANKI 020 Manual De Instrucciones

READ MENU

To access the menu from the main template using the arrow keys
N Code
L00 tuA
L01 tiA
L02 tsb
L03 tGP
L04 tAE
L05 AP
L06 BP
L07 tEr
L08 SAb
L09 CP
L10 HC0
L11 SP0
L12 rEL
L13 Set
L14 dCP
L15 dCP
L16 Po
L17 Cor
L18 Uo
L19 UoB
L20 HSt
L21 dFo
L22 dHt
L23 ASP
Name Meaning
Water output temperature Output temperature (in °C) from the water consumption read by the SUW NTC 10k probe.
Water input temperature Input temperature (in °C) to the water consumption read by the SIW NTC 10k probe.
Coil Temperature Input temperature (in °C) read by the SS NTC 10k probe in the condensation battery.
Force gas temperature Temperature (in °C) read by the SGP probe on force gas.
Outside air temperature Temperature (in °C) read by the SAE NTC 10k probe.
Delivery pressure Bar pressure read by the compressor delivery transducer.
Suction pressure Bar pressure read by the compressor pressure suction transducer.
It displays the percentage of power required by the thermostat on the basis of the proportional/integral
Thermostat
algorithm.
Low water con tent control algorithm. This parameter indicates the temperature threshold for re-starting
Safety band on force-off
the compressor.
CP times Compressor times. This display shows the time to the start or to the stop of the compressor.
Operating hours This screen shows the hours of operation for the compressor.
Pick-ups This display shows the number of pick-ups carried out by the compressor.
Release This display shows the software version.
It displays the setpoint used when the machine is operating: it includes the possible corrections of the
Current setpoint
room temperature (if this function is active).
DCP setpoint Pressure setpoint used for condensation control.
DCP band Pressure differential used when checking the condensation.
Power fraction Power fraction: this reading shows how much power is currently supplied to the machine.
Inverter current Current (in A) measured from the inverter module.
Inverter output voltage Output voltage (in V) measured from the inverter module.
Bus voltage BUS voltage (in V) measured from the inverter module.
Inverter dissipator temperature Heat dissipator temperature (in C°) of the inverter module.
Dynamic ForceOff value The current dynamic ForceOff value calculated in relation to the temperature of the outside air.
DHW remote probe value Value read by the remote probe, located in the water accumulation of the system.
Value of the compressor suction
Temperature read by the compressor suction probe.
probe
Summary of the configurator code set on the machine.
Language selection template.
, scroll down or up to reach the screen shown below
7