User Set Menu - AERMEC ANKI 020 Manual De Instrucciones

USER SET MENU

Access to the list of parameters on entering the user menu
N Code
U00 StA
U01 StF
U02 bnF
U03 StC
U04 bnC
CSt
U05
U06 SF1
U07 tF1
U08 SF2
U09 tF2
U10 SC1
8
Name Min Default Max
Season 0 0
Cooling
-20.0 7.0
setpoint (°C)
Cooling band
1.0 5.0
(°C)
Heating
25.0 45.0
setpoint (°C)
Heating band
1.0 5.0
(°C)
Setpoint
0 0
correction
Cooling
-20.0 12.0
setpoint 1 (°C)
Outside air
temperature at -40.0 18.0
cold1 (°C)
Cooling
-20.0 7.0
setpoint 2 (°C)
Outside cooling
air temperature -40.0 30.0
2 (°C)
Heating
15.0 45.0
setpoint 1 (°C)
Meaning
If 0 - the machine works in cold mode, unless the contact operating mode is
forced.
1 If 1 - works in hot mode. If this parameter is changed while the machine is
operating, it is automatically switched off and switched on again with the
operating mode selected.
26.0 Setpoint temperature used in the cooling mode.
20.0 Temperature band used with cooling mode.
Setpoint temperature used in the heating mode.
*The maximum limit can be configured using the parameter(t) in the menu
Parameter N30 with PSW=30.
The maximum limit becomes 70° if the parameter(8) =4 to allow setpoint en-
try to adjust the boiler.
20.0 Temperature band used with heating mode
SF1
SF2
3
SF1: user set (U06);
SF2: user set (U08);
TF1: user set (U07);
TF2: user set (U09);
For hot and cold operation the operating set is calculated automatically
in relation to the outside temperature based on the logic explained in the
charts.
Visible only with the setpoint correction enabled. Set to cold 1 = tempera-
26.0
ture as per parameter 7.
Visible only with the setpoint correction enabled. Outside air temperature 1
50.0
corresponds to set at cold 1 parameter 6.
Visible only with the setpoint correction enabled. Set to cold 2 = tempera-
26.0
ture as per parameter 9.
Visible only with the setpoint correction enabled. Outside air temperature 2
50.0
corresponds to set at cold 2 parameter 8.
Visible only with the setpoint correction enabled. Set to hot 1. Set to hot
used as first extreme between which the set can be changed.
*The maximum limit can be configured using the parameter(t) in the menu
Parameter N30 with PSW=30.
The maximum limit becomes 70° if the parameter(8) =4 to allow setpoint
entry to adjust the boiler.
SC1
SC2
TF1 TF2
SC1: user set (U10);
SC2: user set (U12);
TC1: user set (U11);
TC2: user set (U13);
TC1 TC2