Microlife PF100 Manual De Instrucciones página 14

• If time/date is not set, data is not
stored-«E1» is shown when switching
off.
1. Press the ON/OFF button to turn the
monitor on. At first, the last result is
shown («0» if there is no data) and
then the device indicates «READY» for
a measurement by two short beeps
and blinking arrows.
2. You can perform the measurement
while standing or sitting upright. For
better comparison of your data you
should always perform the
measurement in a similar position.
3. Hold the monitor with both hands on
the two rubber areas (compartments).
4. Inhale completely and hold your
breath for a moment.
5. Cover the mouthpiece tightly with
your lips.
6. Blow into the measuring tube as
hard and as fast as you can.
12