Gima 28010 Guía De Uso página 8

4. STRUCTURE
This bed consists of controller box, motor, hardware, plastic parts and leather. Among them, the controller box is controlling the
operation of three motors and the hand controller.
This bed includes angel adjustment of the backrest, angel adjustment of the seat cushion,and lifting adjustment of the whole
bed which is an overall and integral structure.
5. INSTALLATION
1. Put the bed to a proper location, according to the overall layout, the daylighting or artificial lightings and operation condition
of the salon's or the home. And keep it in the clean, dry and cool operating environment.
2. Open the Packing Carton to Check Open the packing carton, check if the bed is intact and whether the accessories or spa-
res are complete. Please contact distributor or us if there's any problem.
3. Installation: Place the bed to the proper position. Please note that it is unnecessary to install extra screw on the floor to fasten
the bed, because the original design has take the stability performance into consideration. But please ensure the bed is placed
on a firm and flat ground, so as to prevent any accident. If the bed rotates or slant due to rough ground, you could adjust the
four pieces of plastic feet (M10×30) and nuts (M10) by hexagon open-end wrench, which are fasten on the bottom panel, so as
to ensure the bed is stable.
4. Power Input: Voltage and frequency input shall be AC 100-130, 50/60Hz or 220-240V, 50/60Hz. Plug the bed on the power
supply properly.
ENGLISH
1. Angel adjustment of the backrest.
2. Lifting adjustment of the whole bed.
3. Angel adjustment of the seat cushion.
8