First Time Of Switching On - emmeti EGWW-0712 Manual De Instalacion Y Uso

2. INSTALLER

2.4 First time of switching on

Loading
- Switch off the appliance using the remote control.
- Check that the drain tap is closed
- Take out the mesh filters.
- Remove the dust with a vacuum cleaner.
- Replace the filters, proceeding in the reverse order.- Start filling by
slowly opening the installation water supply tap outside the appliance
- When water starts to come out the air valve, close it immediately and
continue filling until the pressure gauge shows the value envisaged for
the installation.
Check the air valve for leaks.
Check all the joints for leaks.
It is recommended that this operation be repeated after the
appliance has been working for several hours and that the
installation pressure be checked periodically.
This operation must be carried out by specialised technical
personnel.
Draining
- Before draining, put the installation on/off switch to "off".
- Check that the installation supply tap is closed.
- Open the fan coil and the installation air valve.
If anti-freeze has been put into the system, it must not be
allowed to drain away freely since it is a pollutant. It must
be collected and if possible recycled.
This operation must be carried out by specialised technical
personnel.
2.5 First time of switching on
Before starting up the fan coil for the first time and carrying out the fun-
ctional test, it is indispensable that:
- All the safety conditions have been satisfied
- The appliance is correctly positioned
- The electrical, cooling circuit and condensate drain connections have
been carried out correctly
- The shutoff valves are open.
Then:
- Put the installation on/off switch to "on"
- Activate the fan coil using the remote control
- Check operation in the various modes
- Check the fan speeds of operation.
ON
OFF
OPEN CLOSED
ON
OFF
GB GB
41