emmeti EGWW-0712 Manual De Instalacion Y Uso página 44

3. USE OF FAN
3.3 Starting the fan
• Check that the electrical power supply to the unit is correct.
• Pressing the button turns the light ON / OFF red (the unit is off red light).
• Press the ON/OFF key on the remote control.
The infra-red signal is sent automatically. You will hear an audible signal
and the red light on the fan display will light up.
Beep sounds when and when it receives the signal from the remote
Mode and function the conditioner
Attention!
• For correct reception of signals by the indoor unit, the remote control
should be pointed towards it.
• Avoid having obstructions between the remote control and the
receiver on the indoor unit.
• If the remote control is installed on the wall, it should be close to the
indoor unit.
• The remote control should not be:
Allowed to get wet
Dropped
Left in direct sunlight
Left near sources of heat
• Fluorescent lights and cordless phones can upset the operation of the
remote control. If this happens, move closer to the fan.
The unit is a hydronic terminal and its working mode
depends on the chiller or boiler to which it was connected.
In heating mode, the unit will begin to operate only when
the coil temperature is sufficiently high.
In cooling mode, the unit will begin to operate only when
the coil temperature is sufficiently low.
44


 
 
 
AUTO
FAN
ON OFF MODE
FAN
CLOCK
BLOW TEMP
TURBO SLEEP LIGHT
BIP
GB GB