ClearSounds CS-CLA7BT Manual De Instrucciones página 9

With the CLA7BT and phone in close proximity
1 With your CLA7BT off, press and hold the
Multi Function Button on the left side of
your neckloop for more than 3 seconds.
After the LED indicator lights up steadily,
the neckloop is in pairing mode.
2 Perform a device discovery from your phone
(for the detail on device discovery for your
phone, refer to your owner's manual).
When the scan is complete, the phone
displays the devices found
3 Select BT 107 from the list of devices
discovered and confirm per the
requirements of your phone.
4 When prompted by the phone, enter the
passkey 0000. Your phone will confirm
that bonding occurred and the CLA7BT will
confirm it paired successfully with 10 rapid
flashes.
5 The phone information is now stored in the
CLA7BT memory.
NOTE: Make sure the neckloop and phone you
are using are no more than 10m/33 feet apart,
so they are within operable range.
If the neckloop is not successfully paired within
2 minutes, it will automatically leave pairing
mode. If you still want pairing, you will need to
repeat the steps listed above.
9 – ENGLISH