Tinyloc R2 FINDER Manual De Instrucciones página 69

This option also allows you to change the name assigned to the collar in the R2 Finder memory.
The names assigned to the collars must consist of a maximum of 8 letters.
Go to:
MENU>COLLARS>SAVED COLLAR>SET UP>CHANGE NAME>SELECT LETTERS>
END, press the "OK" key
To exit the setup screen press the left arrow key.
5. "COLLAR INFO"
This option provides information about each of the collars saved into the R2 Finder: serial number,
TIN code, software and hardware version and channel.
If the software and hardware version shown is is 0.00, go to "SETUP", press the left arrow key to
exit and your data will automatically be updated.
To exit the setup screen press the left arrow key.
6. "GPS POSITION"
This option gives us the GPS position coordinates of the collar (latitude and longitude in degrees,
minutes and seconds).
To exit the screen, press the "OK" key.
7. "CALIBRATION"
This option is required to calibrate the trantransmitters that work only with radio tracking. It allows
us to perform recalibration of the selected transmitter. Keeping transmitters properly calibrated
guarantees a maximum range in signal reception.
To exit the setup screen press the left arrow key.
8. "DELETE"
This option lets you select a collar and delete it from the R2 Finder memory.
MENU>COLLARS>OK>DELETE>YES/NO>OK
65