Setup And Installation; Ac Power; Fuse Replacement; Fuse Replacement Diagram - Chauvet Professional Net-X Manual De Usuario

Ocultar thumbs Ver también para Net-X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup And Installation

3.
Setup And Installation

AC Power

Net-X™ has an internal auto-ranging power supply that works with an input voltage range of
100–240 VAC, 50/60 Hz. To determine the power requirements for the Net-X™ refer to the
label affixed to the product or Technical Specifications.
The listed rating indicates the maximum current draw during normal operation. For more
information,
www.chauvetprofessional.com.
·
Always connect this product to a properly grounded and protected
circuit.
·
Never connect this product to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to
100% switch.

Fuse Replacement

1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Replace with a fuse of the exact same type and rating.
6. Insert the fuse holder back in place and reconnect power.
Disconnect the product from power before replacing the fuse.

Fuse Replacement Diagram

Spare Fuse Holder
(inside safety cap)
Always replace a blown fuse with another of the same type and rating.
A spare fuse is not included; however, the safety cap has room for a spare.
Page 10 of 0
download
Sizing
Circuit
Breakers
from
the
Installed Fuse
(held by plastic clip)
Safety Cap
Chauvet
website
at
Net-X™ User Manual Rev. 2

Publicidad

Tabla de contenido
loading

Tabla de contenido