Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
c) Press <UP> or <DOWN> until <Without Input> shows in the lower right-hand
d) Press <ENTER>. <Without Input> stops flashing.
5. Configure the DMX ports that will receive Art-Net™ signals by doing the following for
DMX Out ports 1 and 2:
a) Press <MENU> repeatedly until <DMX Output Port #X> shows on the display.
b) Press <ENTER>. The phrase in the lower right-hand corner of the display
c) Press <UP> or <DOWN> until <ArtNet Input> shows in the lower right-hand
d) Press <ENTER>. <ArtNet Input> stops flashing.
6. Configure Art-Net™ universe for the DMX ports that will receive Art-Net™ by doing the
following:
a) <MENU> repeatedly until <Universe #1> shows in the display.
b) Press <ENTER>. The number in the lower right-hand corner of the display
c) Press <UP> or <DOWN> until 4 shows on the display.
d) Press <ENTER>. 4 stops flashing.
e) <MENU> repeatedly until <Universe #2> shows in the display.
f) Press <ENTER>. The number in the lower right-hand corner of the display
g) Press <UP> or <DOWN> until 8 shows on the display.
h) Press <ENTER>. 8 stops flashing.
Art-Net™ And DMX Sources
Art-Net™ and DMX sources configuration uses the Net-X™ as both a DMX splitter and
Art-Net™ adapter. Configure this operating mode by combining the configurations for the
DMX source and the Art-Net™ source, which are described in detail in DMX Source and
Art-Net™ Source. Keep the following in mind when configuring the Net-X™ for use as a
combination optical DMX splitter and Art-Net™ adapter.
· Disable any unused DMX Out ports.
· DMX Out ports can output only DMX or Art-Net™, not both.
Indicators
The three LED indicator lights on the front of the Net-X™, next to the menu display, indicate
when there is power, DMX, or Art-Net™. The table below shows the behavior of the lights
and what it means.
Indicator
POWER
SIGNAL
Net-X™ User Manual Rev. 2
corner.
flashes.
corner.
flashes.
flashes.
Behavior
Solid red
Off
Blinks rapidly in red
Blinks slowly
Blinks rapidly in red
DMX
Blinks slowly
While Net-X™ is powered on, the Signal and DMX indicator lights will blink slowly when
nothing is plugged into their ports. These indicator lights will blink rapidly after cable
connections are made and the Art-Net™ and DMX signals are being received by Net-X™.
Configuration And Operation
Meaning
Power is getting to the Net-X™
Power is not getting to the Net-X™
Art-Net™ signal is getting to the Net-X™
Art-Net™ signal is not getting to the Net-X™
DMX signal is getting to the Net-X™
DMX signal is not getting to the Net-X™
Page 17 of
Publicidad
Tabla de contenido
