How To Use; Night Light - HoMedics UHE-WM65 Guia De Inicio Rapido

How To Use

Power ON/OFF Button
Warm Mist Button

Night Light

Illuminated Ring
Power ON/OFF Button
Plug unit in to a 120 volt AC electrical outlet. Press the POWER ON/OFF
on. Press the POWER ON/OFF button again to turn unit off.
ATTENTION: When the water in the tank is almost empty, the humidifying function will power
off to indicate to the user to refill the tank.
Mist Adjustment Setting
Mist adjusts from Lowest output to Highest output. To increase the mist output, turn the MIST
adjustment knob clockwise. To decrease mist output, turn the MIST adjustment knob counter-
clockwise.
Mist Temperature Setting
When the humidifier is powered ON, it will be operating on the default setting—Cool Mist. To
change the Mist Temperature from Cool Mist to Warm Mist, press the WARM MIST
button. The mist temperature will change to Warm Mist, and WARM MIST button will be
illuminated red. To change the Mist Temperature back to Cool Mist, press the WARM MIST
button again. The mist temperature will change to Cool Mist, and the light in the WARM MIST
button will turn off.
NOTE: Once warm mist is selected, it will take 20 minutes before the mist becomes warm.
Night Light
Press the NIGHT LIGHT ( ) button to turn on the night light. The surround around the
POWER/MIST knob will glow softly.
Night Light
ON/OFF Button
Mist Increase / Decrease
Adjustment Knob
Fig. 2
button to turn unit
6
How to Fill
CAUTION: Before filling unit with water, turn the power off and unplug the unit from the outlet.
NOTE: Always use two hands to carry the water tank.
1. Grasp tank handle with both hands and lift up from
Fig. 3
humidifier base. Remove only one tank at a time. (Fig. 3)
2. Turn the tank upside down—remove the tank cap by
Fig. 4
turning it counter-clockwise. (Fig. 4)
3. Fill the water tank with clean, cool water (not cold). We
Fig. 5
recommend using distilled water if you live in a hard
water area. (Fig. 5)
4. Replace the tank cap by turning clockwise until tight.
Fig. 6
(Fig. 6)
5. Install both tanks back on the base of the unit.Make
Fig. 7
sure the tanks are firmly seated. (Fig. 7)
NOTE: This unit uses water from one tank at a time. It will
use all the water from one tank before beginning to pull
water from the other tank.
NOTE: It is normal to have a small amount of water in the
base during and after use.
7