SOMFY pujol SPIDER PRO 600 Instrucciones De Instalación Y Reglaje página 22

assembling the rail to the motor head (fig. 6)
mounting the assembly on the garage ceiling (fig. 7 to 9)
mounting the lintel yoke (fig. 7)
mounting to the ceiling
• Attached ceiling: mounting directly to the ceiling using the rail (Fig. 8).
• Detachable ceiling: mount the system at the motor head (Fig. 9)
For adjustable intermediate mounting along the rail, or mounting at a dimension h between 250 mm and 550 mm, use the ceiling mounting kit (Fig.
9- ).
mounting the arm to the door and carriage (fig. 10)
[1]. Release the carriage using the manual back release device.
[2]. Bring the carriage level with the door.
[3]. Secure the arm to the door yoke and carriage.
adjusting and mounting the opening stop (fig. 11)
[1]. Release the carriage using the manual back release device and move the door to the open position.
Do not open the door fully, but position it so that it does not reach its stops.
[2]. Position the stop against the carriage and secure it to the rail.
mounting the chain bearings (fig. 12)
For chain rails only.
Position each of the bearings in the first hole in the rail, outside the end limits.
Ensure that the bearing is fully pushed in so that the positioning lug protrudes past the outside of the rail.
Checking the tension of the chain or belt (fig. 13)
The rails are supplied pre-tensioned and checked. If necessary, adjust this tension.
The rubber must never be completely compressed during operation.
Connection to the electrical power supply (fig. 14)
[1]. Fit the light.
[2]. Connect to the mains supply.
Warning light B flashes twice continuously to indicate that the motor is waiting for auto-programming.
Connect the power supply cable to a socket provided for this purpose and which complies with the electrical requirements. The
electrical line must be equipped with protection (16 A fuse or breaker) and a differential device (30 mA).
An all-pole supply cut-off device must be provided:
. either by using a supply cable fitted with a plug;
. or by using a switch ensuring a minimum separation distance between the contacts of 3 mm on each pole
(see EN60335-1 standard).
Check that the manual back release device is a maximum of 1.80 m from the ground.
If necessary, extend the lead.
SPIDER PRO 600
4
automatismos pujol - - english
https://appceso.com