Using Your Appliance - Moulinex soup & co Manual De Instrucciones

Using the control panel (B)
Selecting a programme:
P1 Automatic programme - Creamy soup
P2 Automatic programme - Chunky soup
P3 Auto clean (Automatic cleaning
programme)
Increasing the time or temperature
Decreasing the time or temperature
2 functions for this key:
- OK (to confirm your choice of the
programme, temperature and cooking
time).
- OFF (to stop the appliance after you
have started it. Press the key for
2 seconds to reset the time and
temperature)

USING YOUR APPLIANCE

Programme mode:
You can select an automatic programme after putting
water and ingredients into the bowl:
Plug in the appliance; the LCD screen
0
displays "00.00".
max
ice
1- Press the P key to select the programme
P1 (Creamy Soup). The mark
the selected programme.
2- Press the P key again to select the
programme P2 (Chunky Soup). The
mark
programme. Warning: The programme
P3 is used only for cleaning the bowl
(Auto-clean).
3- The Time setting flashes: you can
modify this setting if you want to. If
necessary, adjust the time using the +
(increase) and – (decrease) keys,
depending on the ingredients used and
the volume prepared (see table below
for practical tips).
points to
points to the selected
0
Selecting the motor speed.
5 speeds and Pulse (short bursts).
max
Crushed ice function
ice
Heating indicator light: it turns on as
soon as the cooking starts and turns off
when the temperature inside the bowl
drops below 50 °C.
Safety locking
• The appliance will operate only when the bowl (D) and
lid (E) are correctly positioned and locked on the
motor unit (A) (see Fig. 3 and 4).
Use the trigger (d2) inside the handle to
unlock the bowl and remove it from the
motor unit.
4- Then confirm the selected programme
0
and time with the OK key.
The red light turns on, indicating that the
max
cooking has started. With programmes
P1 and P2, the blending will be done
automatically when the cooking is
complete.
5- When the programme is completed, the appliance will
beep 3 times.
6- At the end of the programmes P1 and P2, the appliance
will automatically switch to keep-warm mode for 40
minutes to keep your preparation hot until it is ready to
serve. To stop the keep-warm mode, just press the OFF
key.
The keep-warm mode will stop automatically if you open
the lid, press the trigger or remove the bowl.
7- Press the trigger (d2) and lift the blender
bowl (D).
After the programme has started, you can stop the
appliance at any time by pressing the P key. The
programme will then be in pause mode; you can restart it
by pressing P again or the OK key.
If you have chosen the wrong programme and want to
cancel it, press the OFF button for 2 seconds.
10