Snooper TruckmatePRO S5000 Guia De Inicio Rapido página 7

4. Installing the Truckmate using the Windscreen Suction Cup bracket
You can mount your Truckmate to the inside of your vehicles windscreen using the
windscreen bracket provided.
Clean the area where you wish to position
● ●
the bracket thoroughly with a good quality
glass cleaner. This allows a more secure seal
on the windscreen.
Place the suction cup and bracket on
● ●
the windscreen and push the locking
lever towards the windscreen to secure
the bracket.
Adjust the angle of the bracket so that
● ●
when the unit is attached to it you can
view the display and operate the controls safely.
Position Truckmate onto the bracket, by
● ●
inserting the bottom of the unit first and finally
clipping the top of the bracket into the slot
on the top of the unit. To remove Truckmate
simply unclip the unit, by pushing the top of the
bracket and taking the unit from the holder.
Truckmate can be powered directly
● ●
either from the internal battery if it is fully
charged or powered from the cigarette lighter
socket. To use the cigarette lighter
socket, plug the USB connector on one end of the power cable into the USB socket on
the left hand side of the Truckmate and plug the larger plug into the cigarette lighter
socket of your vehicle.
Please Note: Only use the cigarette lighter power cable provided with Truckmate.
Truckmate operates on 5V and using any other cigarette lighter power cable will
damage your device and void the warranty.
Locking
lever
7 • UK
Bracket
adjusters