Attaching The Guide Fence; Connecting The Vacuum Sawdust Extraction Device; Setting The Cutting Angle; Setting The Speed - Parkside PPHSS 730 Instrucciones De Utilización Y De Seguridad

Attaching the guide fence

Q
The guide fence can be attached on the left or
19
right side of the device (see Fig. A).
j
Release the two locking screws of the fence
guide openings
15
j
Slide the guide fence
openings .
15
j
Retighten the two locking screws.
Connecting the vacuum
Q
sawdust extraction device
j
Insert the dust extraction spout
vacuum extraction duct
j
Connect a vacuum device approved for the
extraction of sawdust and splinters to the dust
extraction spout
7
operation
Q

Setting the cutting angle

Q
j
Release the clamp screw
key .
20
j
Set the cutting angle 0° / 15° / 30° / 45°
(left / right) on the base plate
marking for each recessed line indicates the
cutting angle setting. The housing has a stop
pin (see Fig. B) which must engage in the
21
appropriate recessed line.
j
Tighten the clamp screw
key .
20
.
into the fence guide
19
into the
7
until it engages.
8
(see Fig. C).
using the Allen
11
. The embossed
9
using the Allen
11
Preparing for use / Operation

Setting the speed

Q
j
Set the desired speed using the oscillation
speed setting wheel
j
If possible always determine the optimum
setting beforehand by carrying out a
practical test.

Setting the pendulum action

Q
You can set the pendulum movement of the saw
blade using the pendulum action switch
14
having no pendulum action (setting "0") you can
produce fine, clean cut edges. Turn off the
pendulum action for thin workpieces.
With the pendulum action activated (settings 1 – 3)
you can cut through the workpiece at increasingly
quicker rates.
j
If possible always determine the optimum set-
ting beforehand using a practical test.

Switching on / off

Q
c DAngEr! Before connecting to the mains
plug check that the mains circuit supplies
230 V ~ 50 Hz and is fitted with a 16 A fuse or
cut-out in accordance with the regulations!
Switching on:
j
Push the On / OFF switch
and ensure it engages.
Switching off:
j
Press the rear part of the On / OFF switch
.
4
. By
12
into position "I"
2
2
GB/MT
.
31