Configuration - Zenner EDC Manual De Montaje Y Operacion

Deutsch English
3. Mounting respective retrofitting of the EDC module on a water meter
The ZENNER EDC modules have been developed
for all ZENNER water meters whose registers are
equipped with AMR/AMI modulator disc (Picture 1).
Depending on the version, the registers are equipped
with 6- or 8-digit roller counters.
Picture 1: ZENNER register with modulator disc
Depending on the register version (standard dry
dial or copper-can) two different EDC casing
types are available:
Picture 2: EDC with fixing clip/screw (EDC-C)
Picture 3: EDC with fixing screw (EDC-S) for
meters with copper-can register (IP68)
10
Français Italiano
3.1. Mounting (retrofitting) with fixing
Remove the metallic sticker from the bottom of
the EDC module. Place the EDC on the previ-
ously cleaned register as shown on picture 4
and press it firmly. Make sure that the screw
passage and the recess in the register cap fit
correctly. Additionally, secure the EDC with the
enclosed fixing screws. Then stick the two yel-
low adhesive security seal stickers over the
screws. If necessary the water meter lid has
to be changed against the supplied lid which is
fitting with the EDC module.
3.2. Mounting with fixing screw (EDC-S)
Place the EDC on the previously cleaned register
and fasten it with two fixing screws as shown in
picture 5. Then stick the two yellow adhesive se-
curity seal stickers over the screws.
If necessary the water meter lid has to be
changed against the supplied lid which is fitting
with the EDC module.
Picture 4: Mounting of
the EDC-C.

4. Configuration

The local configuration is only required in case of
retrofitting of the EDC module on a water meter.
Otherwise the configuration has been made
during manufacturing.
España
clip/screw (EDC-C)
Picture 5: Mounting of the
EDC-S on the copper-can
register (IP68)