Factory Defaults - Eaton Metalux IB519008EN Suplemento De Las Instrucciones De Instalación

Features
SVPD2 Coverage Pattern
Top View
Side View
SVPD3 Coverage Pattern
Side View
1. The coverage pattern shown above depicts the area
below the luminaire where the integrated sensor
system can detect occupancy.
2. Spacing between fixtures should not exceed the
coverage pattern of the sensor.
3. Mounting height should not exceed coverage pattern.
4. Exceeding these spacing/height guidelines will result
in reduced integrated sensor performance.
Installation Instruction Supplement – Luminaire with Integrated Sensor
Start Up Behavior
Item No. Action
1
2
3
4

Factory Defaults

Occupancy Detection
Default Occupancy Time
Out
Occupancy Sensitivity
Energy Saver Scene
Fade Up Time
Fade Down Time
Default Daylight
Harvesting Level
Default Unoccupied Light
Level
*SVPD2, **SVPD3 @ 30 ft.
Programming Remote Functionality
1.
2.
3.
Turn power ON to the fixture.
The light will start at 50% light level and then
raise or lower to the daylight level.
The sensor RED LED should slow blink (ON for
2 seconds, OFF for 2 seconds) for a 1 minute
duration then blink only on occupancy.
Wait for next daylight adjustment/occupancy
action.
Auto-on, Active
20 minutes
High
100% - Occupied Scene
32% per second using "Raise"
24% per second using "Lower"
500 Lux*, 250 Lux**
Off
An optional programming remote
is available to change the integrated
sensor default settings.
Only one remote is needed to
program multiple luminaires with
integrated sensors.
Refer to the Integrated Sensor
Remote Programming Guide
for detailed information on the use
and programming of the integrated
sensor and programming remote.
EATON
IB519008EN Installation Instruction Supplement
ISHH-01 Remote
3