golmar V2PLUS Manual De Instalación página 100

MONITORS PROGRAMMING
P
rogramming the monitors
Locate the configuration dip switch situated under the protection cover
of the EL500/V2PLUS microprocessor circuit and set umber 2 to
ON as described on page 92
The door panel will reproduce a sound to advise that the system
has entered into programming mode
Master
double
click
nd
2 Slave
Each apartment must have one master unit only; if there is a parallel unit, be it a monitor or
telephone, it must be configured as slave.
.
.
With the door release push button pressed, pick up the
monitor's handset.
To show that the system is ready for programming, the door
panel and the monitor's handset will reproduce tones and
an image will appear on the monitor. Audio and video
communication can also be established
T he door release push button can be released
To program the monitor as master, replace the handset
To program it as
once. After the door panel and handset reproduce a short
tone, replace the handset If a long tone is reproduced
then an error has occurred; reconfigure the monitor
st
1 Slave
To program it as 2 Slave press the lock release push button
twice. After the door panel and handset reproduce two
short tones, replace the handset If a long tone is
reproduced then an error has occurred; reconfigure the
monitor
Make a call to check that the monitor has been successfully programmed
Repeat these steps to program the rest of monitors
Once the programming has finished, set the programming switch to
you don't, the door panel will reproduce a sound to advise that the system
is still into programming mode
n
.
P ress the door panel push button that will
call to this monitor
At this moment both door panel and
handset will reproduce tones
st
1 Slave press the lock release push button
.
nd
.
.
.
.
.
.
.
.
.
.
OFF. If
99
.