Pump Saver - Blue Clean AR 383 Manual Del Proprietário

Fig. 25
Fig. 27
En - 12
•
•
Fig. 26
•
P
Pump Saver is a product that protects and prolongs the life
of the pump. This will keep the internal parts of the pump
lubricated and protected from freezing while being stored in ALL
climates. It also assists with protection from internal corrosion.
The Blue Clean part # is: PW64511 (16oz. bottle ).
Pump Saver Instructions
Follow the previous storage instructions for your power washer. To
prevent staining, protect the surface under the power washer from
any excess fluid. Wear eye protection when using this product.
1. Turn off pressure washer.
2. Disconnect high pressure hose and gun from pump, and drain
3. Unscrew top from bottle to remove seal.
4. Reattach threaded top to bottle.
5. Remove black cap from bottle.
6. Attach to pressure washer inlet.
7. Secure by turning clockwise direction.
8. Turn washer on. Draw contents into pump by gently squeezing
9. Turn washer off as soon as the Pump Saver begins to exit the
nozzle head with fresh water to prevent clogging.
Wrap the power cord around the accessory holder using
the extension tabs at the 3:00 & 9:00 position and the
L-shaped power cord holder/tab located at the 6:00
position (Fig. 25).
The pressure hose is stored on the hose reel located
above the accessory holder. With the front of the power
washer facing towards you, insert the un-threaded end of
the power hose into the square hole on the inner reel and
begin turning the handle away from you (Fig. 26). After
you have the reel turned about 1/4 turn, with the fitting
inserted into the square hole, place the hose under the
indentation on the side of the reel to keep it in place while
winding it up (Fig. 27). When finished winding, push the
handle in to lock it in place. Please remember: the hose
reel is only for storing the high pressure hose. The hose
must be completely removed from the hose reel each time
you use the power washer.
DO NOT store the power washer where it is exposed
to freezing temperatures unless you use Pump Saver.
It is recommended that you use Pump Saver for storing
in freezing temperatures. Freezing will damage the pump
unless Pump Saver is added to the power washer. If not
using or if storing your power washer for more than one
month, run Pump Saver through it. See the section on
Pump Saver for more information.
s
UmP aver
water.
bottle.
pump outlet.